Feature

●🌞【High Performance MCU】BTT MMB CAN V1.0 is a control board to for Voron Enraged Rabbit Carrot Feeder System, which provides a perfect solution for multi-filament feeding to Voron 2.4 and other 3D printers that runs Klipper. This board adopts 32 bit, 64 MHz ARM Cortex-M0+ series MCU--STM32G0B1CBT6 for precise control and excellent print quality in your ERCF project.
●🌞【Redundant Design 】MMB CAN V1.0 is equipped with 2+2 EZ drive sockets and 1+10 Enstop ports. Our redundant design provides backup interfaces and supprots DIY AMS project, increasing reliability and flexibility. MMB CAN supports klipper only.
●🌞【Multiple Reserved Interfaces】I2C interface provides easy connection of BME680/BME280 sensor(to obtain real-time environmental monitoring) and filament runout/clogging sensor; Infrared sensor interface to connect TCRT5000 for precise detection and auto-calibration. RGB interface allows easy addition of NeoPixel/WS2812 LED strip.
●🌞【CANBus and USB Supported】MMB CAN V1.0 board supports CAN or USB communication, with selectable 120R terminal resistance for CAN and reserved CAN expansion interface. We use XT30 interface for CAN communication and board power supply to simplify wiring. CANBus can also provide reliable communication and stable data transmission for smooth and efficient printing. The USB port has ESD protection to prevent controller damage from electrostatic discharge.
●🌞【Polarity Protection】The power interface has reverse polarity protection to prevent the board from being damaged if power cables are connected incorrectly during DIY. !!Note: Detailed set-up intruction can be found in BTT GitHup: github/bigtreetech/MMB. And BIQU is always ready for help, so please donot hesitate to contact us if you have any problem about BTT MMB CAN V1.0.


Description

BIGTREETECH MMB CAN V1.0 Board + EZ2209 Stepper Drivers