Feature

●--E-Heater using precision circuitry to control its heating module.
●--Keep the temperature tolerance within 1℃.
●--Depending on the material and personal choose,the temperature can be set to:40℃，50℃and 70℃.
●--Heaterdesigned for heating composite resin material,improve the flow of its adhesive properties.
●--It can also be used to heat adhesive when used manual equipment.


Description

1.Description of product
1.1 Heater designed for heating composite resin material,improve the flow of its adhesive properties;At the same time it can also be used to heat adhesive when used manual equipment.
1.2 Heater use the precision circuit control module to heat,control the temperature tolerance within 1 degree,According to your choice of material and it can set any integer temperatue within 40-70℃.

2.Operation
2.1 After plug the power supply,the digital tube is always on ” -- ℃ ”.
2.2 After plug the power supply,single press “ ON/OFF/SET ”.
Heater goes into the heating state according to the set temperatue at previous power-off.It automatically stops heating after reaching preset temperatue.
2.3 After plug the power supply,single press “ + ” or “ - ” into the setup mode.Press “ + ” can increase the preset temperatue.Press “ - ” can decrease the preset temperatue.After setting,single press “ ON/OFF/SET ” into the heating state.It automatically stops heating after reaching preset temperatue.

3.Technical parameter
3.1 Power adapter：
Input：AC100-240V 50/60Hz
Output：DC15V2A
3.2 Heating temperatue range:40℃-70℃，±1℃