2 Pack Universal Pop Up Drain Ball Rod Assembly, fit pop up drain ball on most faucet.
Instructions:
1. Remove the nut that holds the old ball rod to drain. Retain nut and washer if applicable.
2. Remove washers that hold ball rod to pull rod assembly.
3. Slide new ball rod through pull rod assembly. Place cone washer on to end of ball rod as shown in image.
4. Slide existing nut and washer if applicable onto new ball rod.
5. Select the ball that best fits the hole where the ball rod assembly and drain assembly meet. Slide ball onto ball rod.
6. Reassemble ball rod assembly to drain assembly.
Three different ball sizes.
SMALL BALL Diameter: 0.59in
MEDIUM BALL Diameter: 0.67in
LARGE BALL Diameter: 0.72in
The rod is 5.9in in length and 0.22in in diameter. When you screw the rod into the ball, it will go in about 0.16in. 3 Sizes of balls, after screwing in, the overall length is 7.24in.
Specification:
Material: yellow zinc dichromate plated steel, plastic
Package Included:
6 x Pop up balls
2 x Rods
4 x Cone washers
Notes:
The brands related above are only for purposes of demonstrating compatibility, not use as trademarks, our trademark is Enhon.