Feature
●Marine-Grade Power: The KENWOOD Marine/Motorsports Car Amplifier KAC-M8005 is a 5-channel powerhouse designed for marine and motorsports applications, delivering 1600 Watts of powerful and reliable performance.
●Built to Withstand the Elements: With its conformal-coated circuit board, this amplifier is waterproof and saltwater resistant, ensuring durability and longevity in harsh marine environments
●Versatile Compatibility: The KAC-M8005 can be used on boats, ATVs, or cars, making it a versatile choice for enhancing your audio experience across various outdoor vehicles.
●High-Pass Filters for Enhanced Sound: Enjoy optimized sound quality with high-pass filters on the front and rear channels, directing specific frequencies to your speakers for a balanced and accurate audio reproduction.
●Premium Marine Audio Solution: Engineered as a marine-grade amplifier, the KENWOOD KAC-M8005 is the perfect choice for outdoor enthusiasts seeking a waterproof, marine audio power amplifier to elevate their marine or motorsports audio system.
Description
Kenwood KAC-M8005 - Power your whole system
Kenwoods KAC-M8005 5-channel amplifier can power your entire sound system, sending out 50 watts RMS each to your four full-range speakers, and up to 500 watts RMS to your sub. Want to run a set of high-performance components plus a subwoofer? You can set the KAC-M8005 to 3-channel mode, driving your components with 150 watts RMS per side while still sending 500 watts to your sub.
CEA-2006 Compliant
CEA-2006 is a system of testing and measurement methods for mobile audio amplifiers. This voluntary standard advocates a uniform method for determining an amplifiers RMS power output and signal-to-noise ratio. The criteria for measuring power uses a DC input voltage of 14.4 volts and the RMS power output is measured into a 4-ohm load, with 1% or less Total Harmonic Distortion (THD) plus noise, and over a frequency range of 20 Hz to 20 kHz, when applicable. Signal-to-Noise ratio is measured in weighted absolute decibels (dBA) at a reference of 1 watt into 4 ohms. CEA-2006 allows consumers to compare car amplifiers and receivers on an equal basis. Using CEA-2006 criteria, the Kenwood KAC-M8005 is rated at 50 Watts RMS x 4 channels + 300 watts RMS x 1, with an 80 dBA signal-to-noise ratio.
Class D Amplifier Design
The amplifier design is Class D, which uses digital switching power supplies. The result is the amplifier runs more efficiently, generating less heat than Class AB amps. The Class D design also allows the amplifier to be built on a small chassis, and installed where space is limited.
Connections
- Line In: The KAC-M8005 has three pairs of RCA inputs for connecting the amp to the source unit via RCA cables. The amp will accept a low-level signal between 200mV and 5V. It will also accept a speaker level input between 4V and 12V. For a speaker level input, the source units speaker wires will need to be spliced onto RCA plugs, or use a third-party speaker-to-RCA adapter.
- Power/Ground/Remote Turn-on: The amplifier has screw-down terminals for the power, ground, and remote turn-on, and will accommodate spade connectors. The power and ground terminals are 0.55" wide, while the remote turn-on terminal is 0.33" wide.
- Speaker Output: Five pairs of screw terminals are provided for connecting the speakers. The terminals are 0.33" wide, and accommodate spade connectors. The amplifier is designed for a 4Ω load on the A and B channels, but can can handle a load impedance of 2Ω to 8Ω. The A and B channels can be bridged to a 4Ω-8Ω load. The Sub channel is designed for a 2Ω load or higher.