Specification:
Model KS-KIT150B
Voltage AC 110V 50/60Hz
Power Max. 150W
Intermittent Operation 1/3 min
Temp. of Blade up to 600℃ in seconds
Power Cord Length 3m
Product Weight 601g
Installation:
NOTE: Always unplug cord of the Thermal Cutter (Hot knife)before installing or removing the blades. Allow sufficient cooling time for blades, blade holders and metal thumb wheels before handing.
1 - Loosen the screws on the blade holders with the wrench.
2 - Slide the blade under the square pressure plate until snug
3 - Securely tighten screws to assure the proper electrical connection. Do not over-tighten.
4 - Once the blade is firmly in place, plug in the Thermal Cutter (Hot knife) Unit into a standard power supply.
Caution:
- The Thermal Cutter (Hot knife) blade have a sharpened razor edge, for the cleanest cut always cut in the direction on the sharpened edge.
- Excessive power output and heat generation may cause the blade holders to overheat resulting in damage to the unit. Use only the power output for proper cutting. The blade does not need to be red hot to move through foamed plastics.
- Never burn off excess residue on the hot knife blade. The blades will overheat, warping the blade and potentially overheating the Thermal Cutter (Hot knife) .
- Only operate Thermal Cutter (Hot knife)when it is in contact with the insulation board.
- Allow blades to cool before handling. A hot blade may cause injury or burns to exposed surfaces.
Maintenance:
Constant use of the Thermal Cutter (Hot knife)may result in some material build up on blades and the brass holders. This excess material interferes with the proper electrical and impairs the performance of the blades. The brass blade holders and blades can be thoroughly cleaned with a copper brush.