Feature

●This 8 Ohm, 25 Watt resistance can be connected across the turn signal bulbs to simulate the load of a regular filament bulb.
●This will solve LED related turn signal problems such as hyper flashing, no flashing or burnt out bulb indications.
●One resistance is required for each turn signal bulb.
●Resistance for LED light, 25W 8ohm resistance, wired resistor , 2 X resistance Can be used with LED turn light of cars, bikes


Description

Description:
Beautiful golden aluminium housing
25 watt ,Pre-wired
Dimensions: Approx. 2.65(L) X 2.7(W) X 1.4(H)cm(1.04 X 1.06 X 0.55 inch)
Correct too-fast flashing
Stop bulbs blowing
Package Included:

Fitment:
Resistance for LED light, 25W 8ohm resistance, wired resistor , 2 X resistance Can be used with LED turn light of cars, bikes
( Simply connect the load resistor to the 2 wires (signal and ground) leading to the signal. Polarity is not important. If your signal has 3 wires, then omit the running light wire as this is unaffected when the turn signal is activated.)
NOTE: Resistor will get HOT when signal is activated. Do not mount directly to plastic surfaces.