Feature

●COMBINATIONS: our grommet tool kit contains 1pcs eyelets pliers, 1pcs leather hole punch, and 150pcs Silver 1/2 inch Eyelets
●DIMENSIONS: the eyelets inside diameter is 1/2 (12mm), outside diameter is 0.82 (20mm), barrel height is 1/4 (6mm) and the length of eyelets plier is 8.2 (20.5cm) and the length of leather hole punch is 3.67 (9.3cm)
●CONVENIENT USE: (1) Use the leather punch to punch a small hole in the fabric with a hammer (2) Put the eyelet into the hole and set up the washers (3) Press the eyelet pliers according to the correct direction of the product picture
●WIDE APPLICATION: the design of the eyelet pliers is labor-saving and efficient, and can be used in a variety of scenarios, such as leather, belts, clothes, fabrics etc.
●Note: As you’re pinching grommet down it opens up like a little flower and it grabs the webbing. The back of our air-eye buckle will look like a flower and also be slightly sharp and rough, so please touch it carefully to prevent scratching


Description

Grommet Tool Kit-1Grommet Tool Kit-1

Product Content:

  • 1 × Hole Punch
  • 1 × Eyelet Plier
  • 150 × Silver Eyelets

Instuction--8 Steps

Grommet Tool-2.1Grommet Tool-2.1
Grommets Kit-2.2Grommets Kit-2.2

Product Features:

Eyelets-3.1Eyelets-3.1

Hole Punch Pliers-3.2Hole Punch Pliers-3.2

Leather Hole Punch-3.3 Leather Hole Punch-3.3

Labor-saving eyelet pliers:

The eyelet pliers replace the traditional 2-piece grommets press tool, which is light and labor-saving.

Flowering eyelet:

There are small cracks at the bottom of the eyelet, which is our new design to facilitate the pressing of the eyelet.

1/2 grommets hole punch:

Before using the eyelet pliers, you need to make a 1/2 hole in order to let the eyelet enter, so we intimately match a suitable fabric hole punch.

  • Labor-saving eyelet pliers: The eyelet pliers replace the traditional 2-piece grommets press tool, which is light and labor-saving.
  • Flowering eyelet (without washer): There are small cracks at the bottom of the eyelet, which is our new design to facilitate the pressing of the eyelet.
  • 1/2 grommets hole punch: Before using the eyelet pliers, you need to make a 1/2 hole in order to let the eyelet enter, so we intimately match a suitable fabric hole punch.