1.Cutting tubes.
2.Remove burrs.
3.Put a nut on tubes.
4.Rotate clamp wheel and handle in anticlockwise,then push to open clamp.
5.When install or change a clamp liner,use finger to dig them out from liner holder and then install the clamp liners you need,
notice insert the pin on clamp liner in clamp liner holder,insert tube between clamp liners until the tube touch the stop plate.
6.Pull back the clamp wheel and tighten it in clockwise,be aware of injure of stop place when rotate clamp wheel.
7.Rotate handle in clockwise,eccentric cone will move forward and make flare little by little.Keep ratating the handle 2-3 round after clutch is seperated will make the flare more smooth and perfect.
8.Flare working finished,remove away th tube.
9.Falring work finished,connect nut to connector.