The Latch Extender is proudly made in the USA with the design and quality you can have confidence in.
Every RVer is familiar with the up-and-down dance usually required to get into the RV. First you have to walk to the top of your steps to reach the door handle, then you have to down the steps to swing the door open, then you walk up the steps again to enter the RV. The Latch Extender by MORryde eliminates the need for this dance routine! The extended handle attaches to your existing door latch and makes it much easier to open your door from the ground or from the first few steps.
|
|
|
---|---|---|
Step 11-1/2" clearance above the center of the dead bolt lock and 16-3/8" clearance below the dead bolt lock is required for the Latch Extender to fit. |
Step 2A total width of 5-3/4" clearance is needed from the edge of the door to the outer edge of the Latch Extender. |
Step 32-5/8" off the face of the latch and 3-1/2" off the door are required to ensure that when the door is open, the Latch Extender doesn’t collide with the sidewall of the RV. |