Feature

●XH-M609 DC Voltage Protection Module: Programmable battery low voltage disconnect switch for DC 12-36V lead acid battery and lithium ion battery. Its a protection switch module, not included batteries itself.
●Input Voltage Range: DC 12-36V, Control Accuracy: 0.1V; On-board momentary push button to set the low voltage disconnect parameter and 3 digit red LED display the parameter easy to operation.
●When the battery voltage reach the setting values, the module will disconnect load automatically to avoid the battery from over discharging to prolong the battery lifetime.
●Display is accurate, the switch module is quickly to open and close when near minimum voltage; Settings is stored non-volatile, it can keep set when power off.
●Applications: XH-M609 Charger Module compatible with lead acid, lithium ion battery, solar panel battery.


Description

Digital LED Display Low Voltage Disconnect Switch Cut Off 12V 24V 36V 48V Over-Discharge Protection Module for DC 12-36V Lead Acid Lithium Battery

XH-M609 DC Voltage Protection ModuleXH-M609 DC Voltage Protection Module

Operation Instructions:

  1. Double-click the + number button, then press + or - button, set the stop voltage value
  2. Double click on the-number button, then press + or - button, set the return voltage value
  3. Press the + number button, then press + or - button, calibrate the input voltage display value
  4. Press the - number button, then press + or - button, set the latency start value T. At the time of the output voltage reaches the start value, after the delay T, there is a voltage output, the delay time is 0 ~ 10 minutes, the display category is: 000 or 001 or 005 or 010
  5. Click the + number button to view the stop voltage value
  6. Click the - number button to view the return voltage value
  7. The difference in the difference can be set to 48V, minimum can be set to 0.5V

XH-M609 Charger ModuleXH-M609 Charger Module

Applications: XH-M609 Charger Module compatible with lead acid, lithium ion battery, solar panel battery.

What is the "difference value"?

  • The value between the battery voltage to disconnect and the battery voltage to reconnect.

For example:

  • I want the battery to stop outputting when the battery voltage is lower than 11V and re-output when it is over 11.6V. What should I do?
  • Hold on "+" and set the value as 11. The LED starts flashing. After the flashing stops, hold on "-" and set the difference value as 0.6V.

Q & A:

Q: How long will this module charge the car battery?

A: The module does not charge itself, it only turns on and off the charge.

Specifications

  • Input Voltage Range: DC 12-36V
  • Control Accuracy: 0.1V
  • Compatible Battery: lead acid, lithium ion battery, solar panel battery
  • Board Size: 57 X 42 X 19mm (L*W*H)