[Manta M5P]
[Manta M5P+CB1 V2.2]
Product Profile
BIGTREETECH MANTA M5P is a 32-bit motherboard developed by the 3D printing team of Shenzhen Big Tree Technology Co., Ltd. for Klipper running. It can run Klipper with a core board, which greatly eliminates the mass wiring between the motherboard and Raspberry Pi, and also greatly saves space in the chassis. The BTB headers are designed on MANTA M5P, so that customers can choose to use CM4 or other solutions, thus solving the insane shortage of Raspberry Pi CM4.
Feature Highlights :
1.32bit 64MHz ARM Cortex-M0+ series STM32G0B1RET6 MCU.
2.The thermistor circuit is protected to prevent MCU damage from shorted heated bed and heater cartridge connections.
3.The CNC fans voltage is selectable in 24V, 12V, and 5V, no more need for external stepdown thus preventing board damage from user error.
4.Thermistor connection supports pull-up resistance value setting using jumpers, no more extra module needed for PT1000.
5.MCU firmware can be upgraded via an SD card, or use DFU via Klippers make flash command.
6.BTB connectors are adopted between the motherboard and core board, allowing the choice of other core board solutions in addition to CM4.
7.Integrated SPI and UART mode of TMC driver and DIAG pin, easily configurable with jumpers.
8.Support filament runout sensor, BLTouch, RGB, etc.
9.Replaceable fuse for easy maintenance.
10.Onboard proximity switch port, support NPN and PNP type selection, (24V, 12V, 5V) voltage selection.
11.Onboard SPI interface for connecting acceleration sensor to enable Klippers input shaping.
12.The new E-FUSE fuse is equipped, which can respond quickly, enhance self-protection ability, and greatly reduce the motherboard burnout caused by short circuits or ignition.
Product parameters:
Dimensions:137.5mm x 95mm, for details please refer to BIGTREETECH MANTA M5P V1.0-SIZE-top.pdf.
Mount