Feature(may vary by option.)

●【VHB Tape】3M VHB Tape 5925 is a 0.025 inch (0.6 mm) thick black double-coated acrylic foam tape with PE film liner. The modified acrylic adhesive on both sides bonds to a broad range of high, medium, and medium/low surface energy substrates including metals, glass, and a wide variety of plastics and paints, the very conformable foam provides good contact between substrates even when they are slightly mismatched
●【Features】Fast and easy-to-use permanent bonding method provide high strength and long-term durability. Creates a permanent seal against water, moisture, and more by offering better gap-filling capabilities. Pressure-sensitive adhesive bonds on contact to provide immediate handling strength
●【Multi-purposes】Suitable for solar panels of RV, car holders, LED strip lights, trim, nameplates, address plaques, signs, power strips, mirrors, hangers, toothbrush holders, picture frames, automotive decorations
●【Easy to Use】Eliminate drilling, grinding, refinishing, screwing, and welding, this foam tape is easy to install, just peel off the tape and stick it to the surface of the object. Note: Please cut a corner piece of the liner with a knife when it is hard to peel off
●【Cure Time】After application, the bond strength will increase as the adhesive flows onto the surface (also referred to as “wet out”). At room temperature, approximately 50% of ultimate bond strength will be achieved after 20 minutes, 90% after 24 hours, and 100% after 72 hours

[2  x16.4 Ft]




[0.5  x18 Ft]




[1  x16.4 Ft]





Description

rv 3m taperv 3m tape
A+ 3M 5925A+ 3M 5925
3m tape 59253m tape 5925
3m black double sided tape3m black double sided tape
double tape applydouble tape apply

cleanclean

primerprimer

applyapply

pressurepressure

CLEANING

  • Quick pre-clean of tough spots if necessary
  • Wet cloth to remove contaminants
  • Final wipe with dry cloth

PRIMING THE SURFACE

  • Apply primer, primer on a towel, followed by a dry towel
  • Dauber bottle followed by a dry towel
  • Foam brush
  • Let dry before taping

TAPE APPLICATION

  • Start the tape at the edge of the surface and lay it down, applying constant pressure as you go.
  • Remove the protective liner to apply the other substrate

APPLYING FINAL PRESSURE

  • Typically, this is achieved by the application of greater than 15 psi at the tape bond line.
time to curetime to cure

Brand in this category on Amazon

Sponsored