Feature

●MULTIPLE GASES DETECTION: This portable gas leak detector can detect a large number of flammable gases, like CH4, Methane, Natural Gas, gas, propane. ethanol, gasoline, alcohol, etc.
●DETECTION RANGE: Approximately 50 to 1,000 ppm(Based on Methane),instant response once encounter leakage points.
●EASY TO USE: There is no need to adjust sensitivity. The preheating time is about 30s, it will automatic measure after 30s. The meter will shut down automatically if the concentration is not measured within 5 minutes.
●AUDIBLE AND VISUAL ALARM: When combustible gas leakage is detected, the meter buzzes and the concentration indicator lights up. The higher the concentration, the faster the buzzer, and the more lights that turn on.
●WHAT YOU GET: 1 x CUSBON Gas Leak Detector, 4 x 1.5V AAA batteries, 1 x user manual. CUSBON offers 12-Month Warranty and friendly customer service.


Description

gas detectorgas detector
GAS DETECTORGAS DETECTOR

Specifications

  • Sensor: Gas-sensitive semi-conductor
  • Reaction range: 50~1000PPM (methane)
  • Reactions Sensitivity: Approx.<50ppm(methane)
  • Warm-Up Time: Approx. 30 sec
  • Reactions time: <=500PPM: Approx. 5sec >500PPM: Approx. 2sec
  • Alarm mode: Visible and audible
  • Operating conditions: 0 to 50°C / 20 to 80%RH
  • Storage conditions: -10 to 60°C / 20...80% RH

Detectable Combustible Gas Type

Hydrogen(H2), Carbon Monoxide(CO), Methane(CH4), Ethane(C2H6), Propane (C3H8), Butane (C4H10), Ethylene (C2H4), Propylene (C3H6), Butene (C4H8), Acetylene (C2H2), Propylene (C3H4), Butyne (C4H6), Hydrogen Sulfide (H2S), Phosphine (PH3) , etc.

Great Performance

  • Double Alarm of Audible and. When detected the combustible gas,the concentration indicator lights up with the buzzer buzzes.
  • Lightweight & Compact Design. You can put it into your bags ro pocket to carry easily.
  • High Precision Semiconductor Sensors. This gas leak detector is equipped with a gas-sensitive semiconductor sensor for lower power consumption and more accurate measurements.

11

11

11

30s Warm-up process

The meter will automatically warm up for about 30 seconds, and the indicator will turn on in a cycle.

Ready to work

Move the meter sensor head as close as possible and slowly (3 to 5 cm per second) to the location where you want to check for leaks and then the sensor will alert instantly, audible & visual alarm at the same time.

Auto power off

When no concentration is measured within 5 minutes, the meter will auto power off.

11
11