Product Introduction:
This module is mainly placed behind the stepper motor to obtain the rotation angle of the stepper motor. This principle is to use the AS5600 magnetic encoding, and then stick a magnet on the main shaft of the stepping motor. Information such as the rotation speed of the spindle can be obtained through magnetic encoding.
Product Parameter:
Product name: AS5600 magnetic encoder
Product size: 23mm*23mm
Product Type: Non contact magnetic induction
Output mode: IIC, PWM, voltage, etc.
PS: Manual measurement, if there is any error, please understand!
Interface Description:
DIR: Rotation direction
SCL: IC communication . Interface Description
DIR: Rotation direction
SCL: IC communication clock line
SDA: IC communication data line
VCC:3.3V
OUT: PWN/analog voltage output
GND: power ground
PGO: mode selection (internal pull-up, ground = programming mode B)
(Ground = clockwise value increases; connected toVCC = clockwise value decreases)
Features:
It is made of KB-A grade FR 4 glass fiber board with a thickness of 1.6mm. The board surface is flat and not easy to be bent. Each PCB board has been tested by flying probes before leaving the factory, and the quality is worth relying on.
Non-contact magnetic induction angle measurement module. High precision, multiple output modes, IC, PWM, voltage, etc.
AS5600 is also equipped with an intelligent low power consumption mode, which automatically reduces power consumption. The input pin (DIR) selects the output polarity rotation direction.