Feature

●Product: IR Emitter Cable; Jack: 3.5mm; Total Length: 1.5meters/4.9feet; Detecting Distance:10-18m/33-59ft; Emission Angle: +/- 45°
●Works with all 38-56kHz IR remote control and devices with an IR input port.
●Low current drive, low power consumption, long launch distance, small size installed.
●Applied to infrared forwarding equipment, video transmission equipment, IR remote transceiver, centralized control equipment, etc.
●Please note that the infrared emitter head is glued to the side of the infrared receiver tube, do not cover it, otherwise the device will not be used, and it will be insensitive to remote control by remote control.


Description

IR emitterIR emitter

Instructions for use:

  • Insert the product plug into the interface of the infrared forwarding device. Generally, the interface has an interface similar to the transmitting signal such as IR OUT, IR TX, IR EMITTER.
  • Paste the infrared emitter head at the appropriate position on the panel of the controlled device. The correct position will affect the remote control sensitivity. Generally, look for the dark red translucent panel of the controlled device. Some devices will indicate the R, IR, INF and other characters. You can also use the flashlight to illuminate the panel to see if there are any components in the red box. This component is an infrared receiver tube.

Specification:

  • Product Name: Infrared Emitter Cable
  • Total Length:3 meters/9.8feet
  • Jack:DC3.5mm
  • Material: Plastic, Metal
  • Head Size: 15 x 9 x 6mm / 0.59 x 0.35 x 0.24inch (L*W*H)

45 degree45 degree

Detecting Angle +/-45°:

  • The emission angle is +/- 45°
  • Less than 4 Inch distance from the infrared receiver tube of your device to the emitter is better for the sensitivity.
  • Please note that the infrared emitter head is glued to the side of the infrared receiver tube, do not cover it, otherwise the device will not be used, and it will be insensitive to remote control by remote control.