Feature(may vary by option.)
●SAFE TO TURN ON & OFF FROM A DISTANCE: Infra-red Non Touch Hand Wave Sensor Switches are ideal to avoid catching virus and germs. Unlike any physical switches, these IR sensor switches are contactless, non-invasive, relatively inexpensive and can be used to switch on/off any 12-24VDC LEDs and devices from a distance.
●EASY TO INSTALL AND OPERATE - Each IR sensor switch comes with an adhesive tape for mounting to any clean and flat surface. Simply wave your hand over the infrared sensor to light up your LEDs. Wave your hand over again to turn your LEDs off.
●POWER UP TO 3 AMPS: Works on any 12-24V LED light. You can always just snip off the power plugs, and wire up directly to a low voltage 12 - 24VDC power source. Then wire in your LEDs, LED strips, LED tubes, LED floods, etc.
●ENDLESS POSSIBILITIES: 1000s of creative uses, whether you want to light up your gun safe, kitchen, cupboard, shelf or counter, our high quality IR touchless sensor switch is just what you need. The project ideas are endless, and we love seeing new ways our customers use this sensor switches.
●LIFETIME GUARANTEE: We sell products that last. Our rock-solid guarantee means well replace your IR Touchless Sensor if theres ever a problem. Pass it on to the next generation with confidence.
[3 Amp]
Description
Input voltage: 12-24VDC
Output voltage: Same as input voltage
Maximum current: 3A (36W@12VDC, 72W@24VDC)
Dimensions: 38 x 31 x 8.7mm (1.5 x 1.22 x 0.34 inch)
Input wire length: 100mm (3.94 inch)
Output wire length: 200mm (7.88 inch)
Waterproof?: Slightly water resistant, but not waterproof
Activation distance: within 150mm (6 inch)
How does it work?
When your hand gets closed to the sensor, the switch toggles its state (it turns on if the current state is off, or vice versa). The sensor will have ~1 second hold off time after the state is changed. During the hold off time, the switch keeps the current state and sensor wont do any detection until either the hold off time is passed or your hand moves away. If the hold off time is passed but your hand is still on the sensor, the switch will toggle its state again.
* So how about if something keep staying on the sensor? Will the light keep On and Off?
Yes, It will. But the IR sensor will only turn On and Off few times and then will go to sleep mode. We purposely added this protective logic in the switch for safety. To resume it, just simply move the blocking-object away. The switch will back to normal.