Feature

●Size: M6x70mm. Total length: 70mm. Sleeve length: 50mm. Screw diameter: 6mm. Sleeve diameter: 8mm.
●Made of high-quality 304 stainless steel, corrosion-resistant, sturdy , durable and long service life.
●Can be installed in various masonry, solid concrete, bricks or blocks.
●The anchor needs to drill an 8mm hole in the base material (concrete, bricks and bricks), which should be drilled with a carbide drill bit and used for hammer drilling.
●The hole in the fixing device or the material to be fixed must be larger than the specified diameter of the anchor. M6 diameter anchoring requires 8mm holes on the fixing device.


Description

Specification
Material: 304 stainless steel
Surface treatment: galvanized
Size: M6x70mm
Total length: 70mm
Sleeve length: 50mm
Screw diameter: 6mm
Sleeve diameter: 8mm
Available drill bit model: 8.0 diameter

Installation method:
1. Choose an alloy drill bit that matches the outer diameter of the inner expansion bolt, and then drill the hole referring to the length of the inner expansion bolt. Drill the hole to the depth required for installation.
2. Install the flat washer, spring washer and nut, turn the nut to the bolt and end to protect the thread, and then insert the internal expansion bolt into the hole.
3. Rotate the wrench until the washer is flush with the surface of the fixture. If there is no special requirement, it is usually tightened by hand, and then use a wrench to rotate three to five turns.

Package Included:
10PCS sleeve anchors