Feature

●CLASSIC STYLE BIKE SPEEDOMETER: Chrome Bezel Old School Style Retro Bicycle Speedometer with Crystal Acrylic, Looks Great on Your bike. Big in Size, Easy To Read.
●APPLICABLE: Speed In RPM Odometer 24-27.5 Inch Wheels. Perfect For 26-27" Road Bike, Mountain Bike, Folding Bike, and Old Style Exercise Bicycles. NOTE：This Speedometer MAY NOT Be Compatible with Some Electric-assist Bicycles, and it is NOT for The Quick Release Wheels That Go above 38 MPH . It does NOT fit the small size bike with rise handlebar（Not fit beach cruiser forks）or the bike with disc style breaks.
●EASY TO INSTALL: Simple Installation Only Takes A Few Minutes. Mount The Reader on The Handlebar, Attach The Gear to The Axle of The Front Wheel, Link Them by The Cable. No Need for Batteries and Adjustment Setting. The instructions are on the box. Please do not throw away it until you finish the installation.
●AUTO-RESET: Theres No Reset Button. As A Mechanical Speedo, The Odometer Will Turn to 0 When The Mileage Reaches 9999.9 To Start Over.
●METRIC MEASUREMENT: The Speedometer Is in KPH Which Is The Most Widely Used Measurement, Not in MPH. A Kilometer Is 0.62 Mile. When The Speedometer Needle Indicates 30KPH, the Speed Is Approximately 18.6 Miles Per Hour.


Description

This is a very classic style Bicycle Speedometer, just like the ones you would find on an old classic bike like a Schwinn. This will fit general Bike& Exercycle. But this Speedometer MAY NOT Be Compatible with Some Electric-assist Bicycles, and it is NOT for The Quick Release Wheels That Go above 38 MPH . It does NOT fit the small size bike with rise handlebar（Not Fit Beach Cruiser Forks）or the bike with Disc Style Breaks.

Feature:
Chrome Bezel
Resettable
Left or Right Mountable
Speed in RPM
Connecting “L” is Resettable
Bayonet size is about 2cm
Cable：38cm/14.9"
Type: General Bicycle & Exercycle

Packing including：
1set Speedometer kit

Note:
This speedometer does not work on quick release axles.
There is no assembly instruction paper for it is easy to install.If you dont know how to do please check it online from the following information.

Instructions:
1. Attach the speedometer with the large black plastic screw to the metal mounting bracket by aligning it with the two indentations. Make sure the speedometer is not upside down. (Do not remove the two screws at the bottom of the speedometer)
2. Then attach the speedometer with mounting bracket attached to the middle RIGHT side of your handlebar just right of the stem.
3. Loosen your front wheel, unscrew the quick lease, insert the grey round plastic part INSIDE the suspension forks on the RIGHT side by using the two supplied washers. The metal bracket attached to the round plastic part faces towards the spokes. Reattach the front wheel.
4. Attach the cable to the speedometer (marked "UP" on the cable) and into the grey round plastic part now attached to the front wheel at the RIGHT side inside the brackets. The cable is just long enough to reach from the speedometer to the plastic part attached to the front wheel in a straight line down.