2-inches and 3-inches angle orbital air sander feature:
2-inches and 3-inches angle orbital air sander technical specifications:
Whats in the Box:
Kindly reminder:
Before you use the air sander, please add 2-3 drops of oil from air quick connector and please allow the tool to run for a few seconds after filling to make sure it works well. (oiler not included in our box)
This tool is intended to be operated as a handheld tool and is air-powered. It requires an air compressor that will provide a clean lubricated air, where the air hose is connected to the tool when the tool is running.
|
|
|
|
---|---|---|---|
Safe pressure plate type start-stop switch for safer users and higher reliability |
Stepless speed control knob switch, according to different purposes, choose the different speed to meet different needs |
The 2-inches or 3 inches hook and loop sanding pad easy replaced, that is lightweight and suitable for small areas of grinding and polishing |
Before use, add 2-3cc #60 pneumatic oil to the air inlet to make the fan blade better lubricated. the cylinder cooling then maintains the torque and delays the life of the machine |
|
|
|
|
---|---|---|---|
Replace sanding pad step oneFind the small hole on the top of the angle orbital sander. If you dont find the hole near the outside, use the PIN to hold the rotating block inside. Rotate it a little to find it, then insert it into the hole with the PIN. |
Replace sanding pad step twoHold the PIN, do not let the PIN slide, rotate the sanding pad in the direction of the arrow until the disk is removed from the angle track mill |
Internal eccentric view for angle orbital air sanderYou can find how is the structure for Internal eccentric view of angle track sander |
Replace sanding pad step threeContinue to withstand the PIN, do not let the PIN slide, according to the direction of the arrow in the picture, installing the new sanding pad to angle orbital sander |