Feature

●Three inserts to protect your expensive blades Please measure your saw as some Delta & Rockwell &Grizzly14" bandsaws has slightly smaller holes for the throat plate. If so some slight filing or sanding may be required.If you mind, please dont buy it.
●use on 14" Band Saws and 24" Scroll Saws.
●2&1/2" X .100 thick Please measure your saws recess to ensure proper fit They fit Delta, Rockwell, some Jet, Ridgid, Grizzly, and other imports.
●Make sure your insert recess has the locating pin on the side, not on the rear
●IMPORTANT INSTALLATION NOTE:I have sold several hundred of these and occasionally someone will have the problem of it being a bit too large. First make sure the lip of the hole is free from dirt. If a table alignment pin,is not tight or missing,often the blade mounting slot will close up some over time which reduces the insert hole diameter slightly. I tap a flat head screw driver into the blade installation slot a bit to wedge it open. That should spread the insert hole enough for it to fit


Description

Product Description：

1111

插片插片

1212

Describe:

  • Table Inserts (pack of 3).
  • Material: Aluminum
  • Make sure your insert recess has the locating pin on the side, not on the rear.
  • use on 14" Band Saws and 24" Scroll Saws.2&1/2" X 100 thick Please measure your saws recess to ensure proper fit. They fit Delta, Rockwell, some Jet, Ridgid, Grizzly, and other imports.
  • Three inserts to protect your expensive blades

Attention:

  • Please measure your saw as some Delta & Rockwell &Grizzly14" bandsaws has slightly smaller holes for the throat plate. If so some slight filing or sanding may be required.If you mind, please dont buy it.

IMPORTANT INSTALLATION NOTE:

I have sold several hundred of these and occasionally someone will have the problem of it being a bit too large. First make sure the lip of the hole is free from dirt. If a table alignment pin,is not tight or missing,often the blade mounting slot will close up some over time which reduces the insert hole diameter slightly. I tap a flat head screw driver into the blade installation slot a bit to wedge it

Product information