Feature
●PERFECT FITMENT: Fit for 1984-newer "downsized" Jeep Wagoneer, 2WD and 4WD Cherokee and Comanche, 1987-newer Jeep Wrangler, 1990-newer Jeep Renegade, 1993-newer Jeep Grand Cherokee, 1994-newer Dodge Ram 1/2-ton 4WD pickup
●SUPERIOR QUALITY: Machined from high quality steel to ensure great tolerance and resistance to corrosion and rust. No pieces of steel will stuck between the cup and the axle. No compromises.
●APPLICATION: Adapters designed to both install new and receive old pressed out ball joints. (Use with the OTC 7249 ball joint set to remove or install aftermarket and original equipment upper and lower ball joints)
●ADVANTAGES: These adapters are awesome assistants to remove and install the offset ball joints used to change caster/camber, making the job much easier and safer than just using the generic set of adapters which come with many ball joint presses.
●SATISFACTION GUARANTEE: If youre not 100% satisfied with our Ball Joint Service Adapter Kit, simply return it for a full refund in 30 days. Premium Support & 12-Month Warranty
Description
This Tool Set Makes Ball Joint Service a Breeze For You !
- Fitment: Works with 1984-newer "downsized" Jeep Wagoneer, and 2WD and 4WD Cherokee and Comanche; 1987-newer Jeep Wrangler; 1990-newer Jeep Renegade; 1993-newer Jeep Grand Cherokee; 1994-newer Dodge Ram 1/2-ton 4WD pickup
- Time saver: With this set it took minutes to the removal and installation of the ball joint - 5 minutes to press out, 5 minutes to press in !
- A Must Have tool: This adapter kit is designed to be indispensable tool for removing and replacing press-fit upper and lower ball joints in an easy and safe way.
Package includes:
- 4 Adaptors: 2 for installation, 2 for removal
|
|
|
|
|
|---|---|---|---|
|
Machined from high quality steel, tough enough. No pieces of steel will stuck between the cup and the axle |
The cutout in the receiver means it fits perfectly for the lower ball joint |
The remover works well with the remover cup |
The installer is angled so ball joints can be pressed in straight without the need for washers or shims |
- Note: Just remember the top ball joint presses out upwards and the bottom ball joint presses out downwards! And youll need a big hammer to get the knuckle off.
