Importance Notice Before Use Safety This laser module (if equipped in the device and connected to power source) can emit highly concentrated visible or invisible light which can be hazardous to human eye or body causing its irreparable damage. The operator of the module must be professional adult who is qualified to operate laser products in certain classification. Do not expose the eye or skin to any laser light directly or through optical lens. When handling laser equipment, wear appropriate safety glasses to prevent laser light from entering to the eye. Never look into the beam directly or through optical instruments. Take extra precautions when using the laser module indoors, paying attention to any reflective surfaces. Never point the laser beam at people, animals, vehicles or airplanes. This laser module (if equipped in the device and connected to power source) is classified in Class 3a or Class 3b of IEC 60825-1 Safety/21 CFR1040 of laser products. Please note that even while complying with the above classifications working in the device, the laser modules itself are electronic components intended solely for incorporation or integration with final devices, and therefore are not subject of IEC 60825-1/21 CFR1040 and are not certified in accordance with IEC 60825-1/21 CFR1040. Products incorporating the laser modules must follow the safety rules found in IEC 60825-1/21 CFR1040 or other equivalent standard in force. The way the laser modules are used in final product can change their original safety classification, therefore it is absolutely necessary to perform all required safety measurements for devices into which the laser modules are incorporated or integrated. Ensuring compliance of the final device with the relevant standards rests solely on its integrator. Disclaimer The above specifications of the product are for reference purpose only and may be modified for improvement without prior notice. Every possible effort has been made to ensure that the information described in this specification is fully accurate. However, the is not liable for any damage resulting from inaccuracies in these specifications. The data, charts and all other information dot, line or cross laser module scribed in these materials were correct at the time this specification was issued. The constantly strives to increase the level of its products quality and reliability. Despite these efforts, there may be situations where the products suffer from failures or other problems. Design the product so that the products are used in the operating ranges described above. Foreseeable failures or emergency modes should be considered in designed equipment to ensure that devices containing the products do not cause injury, fire or other damage. Extensive assessments of each individual system as a whole should be made, with the customer taking full responsibility for design decisions and possible damage caused by the system. the is not responsible for any defects or injuries that may be caused by the equipment using the devices.
The prohibits the buyer from reverse engineering, disassembling or taking other steps to obtain a product design. Products described in these specifications have been designed and manufactured for use in general electronics. Please consult the when considering using the products described in these specifications in any critical system requiring high reliability, including aviation, military, nuclear, automotive or life support system.
