Follow the installation instructions for the steps to install
1) Clean the spoiler section on the car with rubbing alcohol.
2) Pre position the spoiler on the car and make sure both left and right end does not have any gap.
Don’t worry about it being center. This is to avoid the edge from lifting apart down the road.
3) With the spoiler on the car, use blue painter tape to mark the spoiler position.
4) Put a tape on the spoiler and body in the center, left, and right for guidance and draw a line on the tape.
5) Add adhesive promoter on the spoiler section of the car and wait until dry (1-2 min)
6) Remove the tape from the spoiler
7) Careful and slowly position the spoiler on the car. Don’t put any pressure until you are happy with the position
8) Use a heat gun and warm the spoiler adhesive while on the car
9) Put pressure on the spoiler For about 1 min after you are satisfied with the position.
10) Use the blue painter tape to hold the spoiler in place for about 48-72 hours.
Make sure the left and right edge does not have any gap without any pressure, otherwise, the edge will start peeling apart.