INSTRUCTIONS
STEP 1:
If you gonna set the tool over your crank.loose the bolt up a little bit to fit either flush on you case or as close as possible.
Pick three mounting holes.Use three of the holes that hold the flywheel cover on and space them out as evenly as you can.
Then put the bolt in,which the hole are most accessible.Thread the bolts as far as you can.Put ting the nut,thread the nut down on top of the little ears.With the bolt in,the tools centred over you crank.
STEP 2:
No matter what you do you want the ears parallel to the case because you want the bolt on the tool to be pushing on the crank straight,you don’t want it to be pushing crooked or anything.
Make sure all bolts our of your case ,then get ready to split the case.If you missed a bolt,you have s really hard time getting this part ,and will break something.
Putting a 17mm socket or wrench on the tool and tighten it.