Specifications:
Material: Grinding 4S+ superhard alloy
Output mode: A: NO (normally open)
Pre-stroke: about 0.5mm
Stroke: 5mm
Repeatability: 0.001mm (condition: operating speed 50-200mm/mm)
Contact life: 3 million times
Protection structure: IP67
Contact force: 1.5N (installation status: vertical)
Contact material: super hard alloy
Housing material: grinding 4S
Contact rating: DC24V 20mA (MAX) (recommended value 10mA) resistance load
Cable: 5m oil resistant °6 core ∞5.5 tensile strength 30N minimum bending radius R7
Protection tube: 2.5m minimum bending radius R25
LED light: normally open
Alarm signal when the stroke is exceeded
Output mode: B: NC (normally closed) (2.5mm from the measurement signal)
Contact rating: DC24V 100mA (resistance load)
Terms and Conditions:
1, the contact can not exceed the stroke of the tool, otherwise the tool and the props will be damaged. (formed as 5.0mm)
2. Please do not release it immediately when touching the tool setting tool by hand to avoid damaging the internal structure of the tool setting tool.
3. When the tool and the tool setting tool are in contact with the tool setting, please do not release it immediately. The tool must be lifted off the contact surface vertically. It cannot be moved laterally. If it moves laterally, it will damage the tool setting tool.
4. When using the blowing function, the air tube has a diameter of 6 mm and an inner diameter of 4-5 mm. Take care to remove the iron filings and cutting oil attached to the contact surface.
Package Including
1 x Open CNC Z Axis Engraving machine