"Kyuionty DC Motor Driver L298 DC 6.5V-27V 7A Dual H Bridge Motor Speed Controller PWM Motor Regulator Board 12V 24V Motor Control Module Industrial with Optocoupler Isolation, 160W
Features:
The power supply voltage is 6.5V-27V, the power supply can not be reversed or exceed 27V, otherwise the module may be burned, it is recommended to connect a 15A fuse in series with the power input terminal.
Dual motor interface, each rated output current 7A, peak current 50A, motor interface can not be short-circuited, it is recommended to connect 15A fuse in series.
A motor with a rated voltage of 24V, a motor with a rated power of 115W or less, and a motor with a rated current of 7A can work for a long time.
The enable signal and the forward and reverse control signals control the voltage to 3-6.5V.
Enable signal terminal (ENA) input PWM can adjust the speed, PWM frequency range 0-10KHZ, PWM minimum pulse width 10us.
Specification:
Dimensions: 2.16 x 2.16 x 0.63 inch / 55 x 55 x 16mm
Mounting Hole Diameter: 0.12inch / 3mm
Package Include:
1 x C Motor Driver Regulator Board
Note:
When installing the reverse side, pay attention to prevent short circuit, you can add insulating pads or copper columns to lift the circuit board.
It is recommended that the rated output current of the power supply is more than 2 times to prevent the power supply voltage from reaching the input voltage required by the motor during startup, otherwise it may cause the drive module to stall. Voltage protection.
The motor interface cannot be short-circuited, otherwise the drive module may be burned. It is recommended to connect a 10A fuse in series with the motor interface.
100% Satisfaction Guaranteed:
If you are not satisfied or have any questions with any Kyuiontys products, please feel free to contact us with email to get a satisfied solution.