Feature

●★Isolated chip 5V power supply (can be shared with the MCU 5V), can also use the on-board 5V supply; the supply voltage 5.5V to 27V.
●★Able to reverse the motor forward, two PWM input frequency up to 25kHZ; two heat flow passing through an error signal output.
●★Just need four lines from MCU to driver module (GND. 5V. PWM1. PWM2); isolation chip 5 V power supply (can share with MCU 5 V).
●★Voltage indication of motor driver output end; can connect heat sink.
●★5V isolate with MCU, and effectively protect MCU; 5V power indicator on board.


Description

Model: ibt-2
Input voltage: 6V ~ 27V
Maximum current: 43A
Input level: 3.3V ~ 5V
Control mode: PWM or level
Duty cycle: 0 ~ 100 percent
Current conditioning output: Yes

Terminal Wiring Instructions
1.Prwm : forward level or pwm signal input, high level valid
2.Lpwm: reverse level or pwm signal input, high level valid
3.R_ En: forward drive enable input, high level enable, low level off
4.L_ En: reverse driver enable input, high level enable, low level off
5.R_ ls: forward drive side current alarm output
6.L_ ls: reverse driver side current alarm output
7.VCC: + 5V power input, connected with 5V power supply of MCU
8.GND: signal common ground terminal

Wiring Instructions
Methond 1:
VCC is connected to 5v power supply of Mcu, GND is connected to GND of MCU.
R_ EN and l _When en is short circuited and connected to 5V level, the driver can work.
L_ PWM, input PWM signal or high level motor for ward
R_ PWM, input PWM signal or high level motor reverse

Methond 2:
VCC is connected to 5V power supply of MCU, GND is connected to GND of MCU.
R_ EN AND L_ EN short circuit and input PWM signal for speed regulation
L_ PWM, pin input 5V level, motor forward
R_ PWM, pin input 5V level, motor reversal