SINGLE POINT GRINDING WHEEL DIAMOND DRESSER SIZE : 2.00 CARAT - 1/2" DIA x 6" LENGTH

SINGLE POINT DIAMOND DRESSER FOR GRINDING WHEEL

Manufactured using high quality raw diamond

YOU CAN CUT THE LENGTH AS PER YOUR SIZE. SUITABLE FOR MOST BENCH, SURFACE, CYLINDRICAL & INTERNAL GRINDING APPLICATIONS. DRESS GRINDING WHEELS EITHER FLAT OR TAPER OF YOUR CHOICE

GRINDING WHEEL DIAMOND DRESSER SINGLE POINT

Mounted with 2 Carat Diamond

This grinding wheel dresser can remove unwanted debris and impurities from the wheel and reveal a sharp, clean cutting surface to restore and extend the life of the wheel.

Engineered By PRAZTECH

Tools right at your Doorstep, with over 5 Decades of Engineering Expertise, Complete tooling solutions

Guidelines While Using PRAZTECH Single Point Diamond Dresser

To use the tool to its optimum level, it would be wise to keep the following guidelines in mind:

Praztech diamond dresser should be mounted firmly into the holder and, the distance between the diamond and the clamp should be reduced to the least, so as to avoid the diamond from getting ruptured due to vibration.
Ensure that the diamond tool is never directed at an angle which is opposite to the direction of the rotation of the grinding wheel. To maintain a sharper point, it is essential to check that a drag angle of approximately 10 degrees to the horizontal wheel radius, pointing in the direction of grinding wheel rotation is maintained.
It is important not to insert Praztech dressers into the grinding wheel at more than 0.001” (0.025mm) per pass. Cuts deeper than this may cause overheating and, thereby, result in excessive wearing of the diamond.
A fast traverse dressing rate will produce an open wheel, enabling removal of large stock. On the other hand, a slow traverse dressing rate will impart a finish on wheel which is appropriate for producing a good finish on the work piece.
In order to maintain a conical point, Praztech dresser should be rotated in the holder at an angle varying from 20 to 40 degrees.
To avoid cracking of the diamond, use ample amount of coolant wherever possible. Always make sure that before beginning with the cutting activity, the coolant is turned on.
In cases, where dry dressing is performed, do not apply the tool incessantly for longer time, in order to avoid high temperature. Allow the tool to cool naturally instead of doing it with the aid of a coolant. A sudden change in temperature can possibly cause fracture to the diamond, essentially not at the time of shock but in the future use of the tool.
A diamond dresser should never be worn down to the shank as this might result in dropping out of the diamond. Unusually, a Praztech diamond dresser mounted in a dressing tool has more hidden points which, if desired, may be used by resetting.
A crucial point to be remembered is not to allow a large flat to develop on the cutting point as this may deteriorate the economic life of the diamond.