Feature(may vary by option.)
●[Specifications] This M6 x 1 thread insert in length 9mm, 12mm and 18mm for nuts diameter 6mm. Please choose the right size before purchasing.
●[Great Value] When a threaded hole is damaged , repairing threaded holes with thread repair inserts is cost-effective.
●[Steel Inserts] Our threaded inserts are made of 304 stainless steel, it does not rusty, and is designed for long service time.
●[Great Design] The thread size is standard, the thread is clear, it is great for thread repair.
●[Wide Range of Applications] This thread insert improves thread strength and wear resistance significantly when used on lowstrength engineering materials such as aluminum alloy, zinc alloy, alloy, copper, plastic and engineering plastics.
[18mm]
[12mm]
[9mm]
Description
How to Use:
- 1. Drilling
- Use the drill bit of the size listed in the parameter table of the wire thread insert to drill the hole. Be careful not to drill the hole into a cone shape. The chips generated by the drill hole must be blown out with compressed air. After drilling, the counterbore should not exceed the depth of 0.4 pitch. Too large counterbore is not conducive to the screwing of the wire thread insert.
- 2. Tapping
- Use special taps for wire thread inserts to tap. The depth of the tapping must exceed the installation length of the thread inserts. After tapping, use a compressed air spray gun to blow out the debris. When the thread accuracy is high, check the tapped bottom hole with a special bottom hole plug gauge for wire thread inserts.
- 3. Installation
- Put the wire screw sleeve into the installation wrench (figure 5 on the right), insert the wire screw sleeve installation tail handle into the guide rod groove of the installation wrench, and turn the handle of the installation wrench to screw the wire screw sleeve into the screw hole. For installation of M14x2 or more phase thread thread inserts, you can use the "T" type slotting simple tool to install; Note: During the installation and screwing process of the thread inserts, there should be no pressing in the vertical direction to prevent jumping teeth. The correct method is slowly screw in the direction of thread rotation.
- 4. Remove the handle (break off the mounting handle)
- Use a breaker to break the mounting handle. Use about 200g of coconut to hit the breaker instantly, and the handle can be removed. Do not use the mounting wrench to rotate in the opposite direction. Do not break the mounting handle. This situation is very easy. As a result, the tail shank was broken and the wire was pulled out.
- 5. Unscrew
- When installation problems occur during the installation of the wire thread insert (such as jumping teeth), the thread insert needs to be removed, and a special sleeve remover should be used to remove the wire thread insert.
Number of Turns Before Installation: 6.9/9.6/14.9
|
|
|
|
|---|---|---|
|
|
|
|
Specification
- Item Type: Thread Inserts
- Material: SUS304
- Model: M6x1
- Thread Specification: M6x1 (mm)
Outside Diameter Before Installation: Approx. 7.5 ~ 7.9mm / 0.3 ~ 0.3in
Diameter of Drilling Drill Bit for Installation: Approx. 6.3mm / 0.2in
1.5D/2D/3D:
Length After Installation:
Approx. 9mm / 0.4in
12mm / 0.5in
18mm / 0.7in
Specification Description:
For Example: M3x0.5X1.5D, which means that after the screw set is completed, the female thread is M3, the pitch is 0.5, and the length is 1.5D (length refers to 1.5 times the diameter, that is, 1.5x3=4.5mm ), the length here refers to the length after installation.
