Feature

●✔EASY TO USE: Single dip and read test strip procedure and optimized color chart make the product ideal for technical and non technical users alike for detection of ferrous Iron (Fe+2) in water
●✔DETECTION LEVELS: Iron, Ferrous (Fe+2)*: Method A: 0. 0, 0. 3, 1. 0, 2. 0, 5. 0, 10, 20, 50 ppm (mg/L)--- Iron, Ferrous (Fe+2)*: Method B: 0, 0. 005, 0. 01, 0. 03, 0. 06, 0. 10, 0. 30 ppm (mg/L)--- *Does not detect Ferric Iron (Fe+3)
●✔COMPLETE KIT: Pack of 30 individually wrapped test strips packed Pocket Pouch with color chart
●✔ACCURATE AND RELIABLE: Components are tested by Quality Control personnel at each step and are rejected if they are outside of specifications. Standards are prepared using calibrated equipment, and concentrations are confirmed by recognized reference methods
●✔ HIGHEST QUALITY: ITS, manufactures test strip products in their USA facility in an environment that allows for reproducibility, accuracy, and traceability based on Good Manufacturing Practices.


Description

If low range detection of fe+2 is what you need, the sensate Idas iron check is the answer. Sen safe Idas iron check is designed to specifically react with iron, without interference from other heavy metals that may be present. Say goodbye to dangerous, time-consuming wet-chemical kits that require extensive training and cost. This patented Test is a simple dip-and-read Test procedure that requires no technical training. Additionally no glass is required to run the Test, and since the chemical concentration is extremely low this method is ideal for use in controlled areas. Simply dip one strip into the water for 30 seconds with a back-and-forth motion, remove the strip and shake once to remove excess water, wait 15 seconds for the color to develop, and match with the closest color match to determine your concentration of iron. For visual detection of total iron (fe+2/fe+3) see waterworks total iron pillows.