（1）Warm up the engine for about 5 minutes to reduce the oil viscosity. Its important that the engine oil is warm (not hot) when extracting. （2）Turn off the engine and loosen the filler cap (for the time being).

（3）Connect the power clip of the pump body directly to the battery. （4）Remove the oil level gauge and insert the thin hose of the pump. (Notice if you put it to the innermost very quickly,it wont work).

（5）Gradually insert the hose while operating the pump.（6）When it is inserted to some extent,the operating noise will change and the oil will start to be sucked up.

（7）Put the thick discharge hose on the waste oil tray. (If you put it directly in the waste oil treatment box, you will not know the amount of waste oil collected.)

Kindly Notes:

（1）The unit just use for drawing out diesel oil and hot engine oil ( the temperature is 40℃-60℃). （2）Please clean the oil - extractor by diesel oil and keep both inside and outside clean.

（3）The unit is unable to use for combustible material such as gasoline paraffin and so on.（4）If the engine oil is cool , please start engine to properly heat up but turn off the engine when use the unit.

（5）Put the waste oil into suitable container to avoid polluting.