Feature

●HIGH EFFICIENT: This oil transfer pump is an ideal equipment for quick easy and clean safety oil-changes. Flow Rate: 3L/min flow rate for engine oil, 4L/min for diesel. Voltage: 12V, maximum current: 5A, maximum power: 60W.
●APPLICATION: This oil pump can change engine oil and diesel for cars, tractor, boat, motorbike, truck, RV and ATV and other 12V vehicles.
●EASY INSTALLATION: You just need to place the inlet/outlet hoses at the appropriate positions, tighten the hose clamps, connect the power clamps anode and cathode to the car battery properly and press the button. Oil will be extracted by itself.
●NOTE: To pump oil properly, please start the vehicle to heat up the oil (to 40~60 degrees)about 15 minutes. Otherwise, the oil change pump may have low suction or jammed.
●WARNING: This oil pump is not use to extract water, gearbox-oil(too viscous) or flammable liquids (fuel, petrol etc).


Description

Oil transfer pump extractor excellent power-driven design makes it quite labor-saving and convenient than manual ones.
No more jacking of vehicles or removing drain plugs. Great value for a simple, low-cost oil change pump.

Material: Plastic & Aluminium
Rated Voltage: DC 12V
Rated Power: 60W
Maximum Flow: 5L/min
Maximum Pressure: 0.8MPA
Motor Oil (40-60 degrees) Flow Rate: approx. 1L / min
Diesel Flow Rate: approx. 250L / Hour
Line Length: approx. 71cm/28

Diesel Flow Rate: approx. 250L / Hour
Inlet Hose Length: 155cm/61
Inlet Hose Outer Diameter: 6mm/0.236
Inlet Hose Inner Diameter: 4mm/0.157
Outlet Hose Length: 124.5cm/49
Outlet Hose Outer diameter: 12mm/0.472
Outlet Hose Inner Diameter: 10mm/0.39

Package:
1 x Oil change pump extractor
1 x Outlet hose
1 x Inlet hose
2 x Hose hoops
2 x Battery clamps
1 x User manual

Note:
1. NOT suitable for extracting: water (no lubrication of the pump), gearbox-oil (too viscous) and easy inflammable liquids (petrol, gasoline, etc.)
2. The working-period for this oil-extractor should not exceed 30 minutes. we recommend a short break after 10-20 minutes continuous usage to allow the unit to cool.
3. Do not pump fuel, petrol, paraffin or other easily en-flammable liquids-Danger! Do not pump water(no lubrication of the pump). Only pump warm motor-oil(40-60degrees) do not pump off motor-oil.
4. If you want to connect this pump to AC power, you will need a power converter.
5. If you have not used it for a long time, it may have no suction, then just pour the water in the pump, and run the pump for a few minutes until the air is all out.