Feature

●【Instructions for use】1. Please pay attention to the direction of the inlet and outlet, the positive and negative poles and the locking hose lock before use; 2. Please start the vehicle and heat the engine oil to 40-60 degrees for about 5 minutes, otherwise, the oil change pump may have low suction or get stuck. 3. CAN NOT be used to extract water, gear oil (too viscous) or flammable liquid (fuel, gasoline,kerosene,etc.).
●【12V 80w Oil Extractor Pump】Oil change pump, a great helper for quick and clean oil changing and transfer, all parameter is verified by multiple test. Diesel Flow Rate: 3.5L/min, Engine Oil Flow Rate(40-60℃): 1L/min, Inlet Tube Length: 1.2m/47.2in, Outlet Tube Length: 1.4m/55.1in, Voltage: 12V, Maximum current: 5A.
●【Premium Quality】We use pure copper for motors.Good conductivity, corrosion resistance and rust resistance, effectively avoid leakage or short circuit. Instead of manual operation, it can help you change oil quickly and cleanly without lying under the car. It is an ideal oil change pump extractor equipment. Efficient, fast and labor-saving.
●【Complete Diesel Change Pump Kit】The oil transfer pump is mini but powerful. With 4.6ft Outlet tube & 4ft Inlet tube, the 8.2ft long battery clamps makes the extractor pump kit possible for being used at large range. The 2 hoops are used to tighten the tubes to avoid oil spilling.
●【Wide Application】Portable and small oil pumps are needed by everyone, simple operation does not need to spend too much time to practice, widely used in motorcycles, Car, Scooters, Boat, Quad Bikes, Trucks, Ship, Forklifts, Marine,Power generation machinery, Tractors, Lawn Mowers and various machinery to change the oil.


Description

VEVITTS OIL CHANGE PUMPVEVITTS OIL CHANGE PUMP
PUMP DETAILSPUMP DETAILS

Package Included:

  • 1 x Pump
  • 1 x Outlet Hose
  • 1 x Inlet Hose
  • 2 x Hose Clamps
  • 2 x Battery Clamps
  • 1 x User Guide

IDEAL FOR ENGINE OILIDEAL FOR ENGINE OIL

FRONT AND BACK IMAGEFRONT AND BACK IMAGE

SUCK THE OIL OUTSUCK THE OIL OUT

GOOD TO GOGOOD TO GO

Easy Operation:

  • Warm up the engine for about 5 minutes to reduce the oil viscosity. Its important that the engine oil is warm (not hot) when extracting.
  • Turn off the engine and loosen the filler cap (for the time being).
  • Connect the power clip of the pump body directly to the battery.
  • Remove the oil level gauge and insert the thin hose of the pump. (Notice if you put it to the innermost very quickly,it wont work).
  • Gradually insert the hose while operating the pump.
  • When it is inserted to some extent,the operating noise will change and the oil will start to be sucked up.
  • Put the thick discharge hose on the waste oil tray. (If you put it directly in the waste oil treatment box, you will not know the amount of waste oil collected)

Product information