Feature

●Nirakoka RV Automatic Transfer Switch has been pre-wired to automatically change the primary source of AC current from shore power to generator or inverter power when activated.
●WIDE APPLICATION — Applied to RVs, speedboats, and various high-power equipment that requires emergency power supply.
●AUTOMATICALLY SWITCH — This Automatic Transfer Switch 50 AMP can be used to automatically switch between inverter power and a generator. It switches to inverter power when the generator stops running. In the event of a inverter power outage, the generator will start automatically. The green L.E.D is lit when generator power is present.
●DOUBLE PROTECTION — Double protection of built-in mechanical interlocks and control circuits prevents two separate 120/240 volt AC power sources from entering the AC distribution board at the same time and causing a short circuit.
●TIME DELAY CIRCUIT — Once AC power from the Generator is sensed by this RV Automatic Transfer Switch, it will start a timer and automatically switch over to generator power supply after a 20-45 sec delay which ensures the generator has sufficient time to run up to speed before electrical load is applied.


Description

RV Automatic Transfer SwitchRV Automatic Transfer Switch
Dominant source Generator (selectable delay)
Open neutral protection No
Reverse polarity protection No
Safety interlocks Mechanical & Electrical
Under-voltage protection No
Overvoltage protection No
Multi-mode surge protection No
Total surge energy rating None
Total surge current rating None

WIDE APPLICATIONWIDE APPLICATION

TIME DELAY CIRCUITTIME DELAY CIRCUIT

DOUBLE PROTECTIONDOUBLE PROTECTION

EASY TO INSTALLEASY TO INSTALL

Applied to RVs, speedboats, and various high-power equipment that requires emergency power supply.

Once AC power from the Generator is sensed by this transfer switch, it will start a timer and automatically switch over to generator power supply after a 20-45 sec delay which ensures the generator has sufficient time to run up to speed before electrical load is applied.

Double protection of built-in mechanical interlocks and control circuits prevents two separate 120/240 volt AC power sources from entering the AC distribution board at the same time and causing a short circuit.

The coating process used on the surface of this transfer switch can be waterproof, rust-proof and anti-corrosion, and can effectively prolong the service life of the product.

pd52 coverpd52 cover
instructioninstruction