MANUAL OPERATION
1.Remove twist cap in the access hole. (located top center of the housing cover)
2.Insert the 11mm deep well socket (included) in the access hole, over the drive spindle tang. Rotate the socket clockwise to retract and counter clockwise extend.
3.When complete, remove socket and replace twist cap, and reassemble the fuse connection.
NOTICE
1.The diameter of the outer tube of your chosen jack, will need to match the existing hole size, or you will need to modify the hole diameter to fit.
2.Failure to block trailer wheels securely could result in personal injury and possibly death.
3.The motor will stall if jack reaches the full extent of travel both in retract and extend directions. There is an over load protection for the jack to shut off power that will auto reset in 15 seconds. After using jack, operator should learn the travel limit stops. The operator should stop the jack before reaching the travel limit.
4.If the motor should stall with the jack in the fully retracted position, and the Toggle Switch is not released, the motor will automatically switch off.