Feature

●【Stable and reliable】Main driver chip L298N, strong driving ability, severe interference, low heating value, post-running diodes, more stable and reliable for Arduino projects.
●【Highly efficient】Double-H bridge design, can drive a 2-phase step motor, a 4-phase stepper or two DC motors,
●【Easy to use】No assembly required. This L298N board is ready for use immediately. Simply wire the engines and electricity, .
●If your drive voltage is 7 V–12 V, you can activate the integrated 5 V logic power supply. After using the integrated 5V power supply, the +5 V power supply in the interface does not require an input voltage, but the 5 V voltage can be removed for external use.
●【How to use】If you use a drive voltage of more than 12 V, For example, if you drive an engine with a nominal voltage of 18 V, you must first deduct the integrated bridging cap for the 5 V output release. Then connect 5 V to the 5 V output connection.


Description

Characteristics:

1.L298N dual H-bridge driver chip, strong driving ability/low heating/strong anti-interference.

2.With large capacity filter capacitors and diode with freewheeling protection function, reliability is increased.

Please note:

1. If your drive voltage is 7V-12V, you can enable the built-in 5V logic power supply. After using the built-in 5V power supply, the +5V power supply in the interface does not require input voltage, but the 5V voltage can be released for external use.

2. If you use drive voltage more than 12V, e.g. : If you are driving a motor with a rated voltage of 18V, you must first remove the integrated 5V output enable cable cap. Then connect 5V externally to the 5V output port.

Specification:
Logic voltage: 5V
Logic current: 0mA-36mA
Storage temperature: -20°C to +135°C
Operating mode: dual H-bridge driver
Driving voltage: 5V-35V
Drive current: 2A (MAX single bridge)
Maximum power: 25W
Driver board weight: 33g/piece
Dimensions: 43x43x27mm
L298N DC Stepper Motor Drive - Usage
Ideal for Arduino, Smart Car etc.
If the drive voltage is more than 12V, please use external 5V logic outputs to switch the H-bridge circuits.

The package includes:
3 x L298N Stepper Motor Driver Controller Board Module DC Dual H-Bridge Modules
20P cable