Feature

●Maximum continuous output current:3A ;Overload short circuit protection current:4A ,short circuit time does not exceed 30 seconds
●Working Voltage:DC 10V - DC 30V;Maximum output power:120W
●PWM Frequency: 500 KHz;PWM Pulse Width Modulation Range: 5% -95%
●Applicable Motor:brush motor
●Please note that this controller has a low frequency causing some types of the motor to whine at low speeds but not all motors will be like this


Description

dsfadfafdsfadfaf

RioRand DC Motor Speed Controller 10V12V24V30V Forward & Reverse

fdsfasffdsfasf
dfsafafdfsafaf
46964696
ewfsdafdewfsdafd

  • Wiring instructions for use

  1. Connect the power cord, ensure that the forward and reverse switch is located in the middle zero position, connect the DC power supply, ensure that the DC power supply voltage range is greater than 10V, less than 30V, ensure that the power output power to meet the motors operating requirements. DC power supply positive and negative terminals do not reverse, otherwise the controller may be damaged.C
  2. onnect the motor, the motor line can not be divided into positive and negative.A
  3. djustment switch, positive and negative switch is used to control the direction of the motor speed, when the switch is located in the zero position, the motor stops.p
  4. otentiometer knob, adjust the potentiometer knob can change the output duty cycle of the governor, the motor speed change.

  • Using 0-10V external voltage control wiring instructions.
  • This controller supports the use of external DC voltage control speed control, use the following steps.

  1. Remove the potentiometer (you can decide to remove it from one side of the board or the potentiometer side according to your needs.
  2. Connect the 0-10V DC control signal to the center pin of the potentiometer.C
  3. onnect the ground wire of 0-10V DC control signal to the right pin of the potentiometer.

dasfdaf213dasfdaf213
dafffdafff