Feature

●Great Compatibility — Works on Caterpillar (CAT) C-10,C-12,C-15,C-16,C-18 and 3406E Engines. (The new puller bridge can be used on all three engines)
●Superior Quality — Advanced heavy duty steel process, durability, anti-corrosion, high precision and hardness to provide a much longer service life.
●Benefits — Used to install and remove injector sleeves. Works in a easier way to save your time and money.
●Includes 6 Tools — 9U6877 Thrust Bearing / 9U7258 Driver Cap / 221-9778 Puller Stud / 4K-0367 Nut - Full / 5P-8247 Hard Washer /128-7889 Puller Bridge.
●100% Satisfaction Guarantee — If youre not 100% satisfied with our tools, simply return it for a full refund in 30 days. Support 12 months’ Warranty. Professional & Sincere Service allows you to take no risks to purchase in E-cowlboy!

Description

Model: CAT C-10,C-12,C-15,C-16,C-18 and 3406E Engines. (The new puller bridge can be used on all three engines)
This high-quality tool group is used to remove and install injector sleeves.
Work in easy way to save your time and money.It will provide you with quality and persistent service.

Remove The Unit Injector Sleeves

NOTICE: Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.

Install the puller stud from Tooling (A) into the unit injector sleeve.
Install the following parts from Tooling (A) over the stud: bridge puller, thrust bearing, hard washer, and nut. See Step 1.
Tighten the nut until the unit injector sleeve is pulled free of the cylinder head assembly.
Remove Tooling (A) from the unit injector sleeve.
Repeat Steps 1 through 4 in order to remove the remaining unit injector sleeves.

Install The Electronic Unit Injectors

Note: Check the fuel passage in the cylinder head assembly. Remove any debris left.

Clean the bore in the cylinder head for the electronic unit injector sleeve.
Install new O-ring seals (2) on electronic unit injector sleeve (1).
Apply Retaining Compound to the contact surface of electronic unit injector sleeve on the surface that is marked "X".(Do not apply it to the cylinder head surfaces)
Lubricate O-ring seals (2) with clean engine oil.
Install Tooling (B) into the threads of electronic unit injector sleeve (1).
Position Tooling (B) and the electronic unit injector sleeve in the cylinder head. Use care not to damage the O-ring seal on the electronic unit injector sleeve.
Use Tooling (C) and a hammer to install electronic unit injector sleeve (1) in the cylinder head.