KARTONMOTOR LS Valve Spring Tool,Replace#OE 67605

Universally Compatible: For all LS engine valve, Chevy GM LS1, LS2, & LS6 style cylinder heads, such as LS6, LS2, LS1, LS3, LQ9, LQ4. Suitable for 4.8, 5.3, 5.7, 6.0, 6.2L LS Engines 67605.

Tips: Applying oil or grease to the tool protects the tool and makes the job smoother.

Installation steps：

1. First remove the valve cover, remove the rocker arm and rocker arm guide.
2. Place the Bottom Aluminum plate on the head where the rocker bolts mounted and place the middle section on top that has the stud and mount it to the head with the 2 supplied bolts make sure the tool is setting in the middle between the 2 valve springs. Hand Tighten using a ratchet and socket. Do not Over tighten you can cause damage to the head if you use a impact.
3. Place the top over the 2 valve springs and install supplied nut. Make sure the stud has grease on it.
4. If you are using the head on an engine mounted head, then you will want to use a fitting of compressed air in the spark plug hole to keep the valve pushed close before tightening.
5. Do not use impact as this will cause the nut to overheat and strip the threads! , only tighten the nut manually and slowly.
6. To keep them from falling into the head, after compressing the spring, you can use a magnet to remove the valve retainer.After removing the retainer, you need to slowly reverse the nut to release the pressure and remove the spring.
7. Install the new springs using the same procedure. Make sure when reinstalling the valve keepers that you get them in place so they will hold properly before releasing the pressure.

High-quality materials

LS Compressor Tool Made of stronger steel plates.Bolt strength is higher and can be used multiple times.

Universally Compatible

Replace#OE 67605

Compatible with Firebird, Silverado, Camaro, GTO, Trans am, Corvette, CTSV, Sierra, Tahoe, Suburban, Pontiac G8 GT GM Trucks More.

Ls Valve spring compression tool for 4.8 5.3 5.7 6.0 and 6.2L LS engines，LS1 LS2 LS3 LS6 Series