Feature

●[APPLICATION]: This rear axle bearing puller can help to pull out semi-floating rear axle bearings quickly and effectively.
●[EASY TO USE]: The washer of the axle bearing puller can captures the bearing firmly to distribute the force to the whole bearing, can avoid damage of the bearings and case.
●[DURABLE MATERIAL]: The rear axle bearing removal tool is constructed from heavy duty cast steel, which has good strength and durability, can provide long service life.
●[SIZE]: The bearing puller remover set includes fittings for main bearing tube: Small: 1" to 1-7/8", Medium: 1-5/16" to 2-3/8", Large: 1-3/8" to 2-7/8".
●[PACKAGE]: It comes with a plastic carry case, for easy transportation, safe storage, and quick organization.


Description

Highlights

  • Constructed From Heavy Duty Cast Steel
  • Bearing puller makes it easy to remove semi-floating rear axle bearings
  • Axle sizes this unit will work with 1" to 1-7/8", 1-5/16" to 2-3/8", or 1-3/8" to 2-7/8"
  • Comes with storage case
  • Slide hammer end thread is 5/8" TPI

11

11

11

11

EASY STORAGE

Heavy-duty plastic blow-molded carrying case for easy transportation, safe storage, and quick organization.

EFFORTLESSLY REMOVE BEARINGS

8MILELAKE Rear Axle Bearing Puller to service semi-floating rear axle bearings on your vehicle; These tools make the job simple and prevent damage to your bearings when pulling; Much easier than claw-type axle bearing pullers that slip off and chew up the old bearings; For removal only, not intended for installation.

EASY TO USE

Slide flat end of puller through center of bearing and flat against backside of bearing, then slide washer down the center of the shaft against front side of bearing and tighten the nut on smaller end of puller, then thread a slide hammer (not included) to the puller and slide hammer back and forth until the bearing comes out; The washer captures the bearing firmly to distribute the applied force over the entire bearing and prevent damage.

COMPATIBILITY

This set works for most American domestic makes and models; Set includes the following sizes to fit main bearing tube – 1 inch to 1-7/8 inches, 1-5/16 inches to 2-3/8 inches, and 1-3/8 inches to 2-7/8 inches; Sizes permanently laser-etched on tool for easy identification; Each tool fits a basic slide hammer with a 5/8-inch x 18 thread pitch.

Product information