Feature

●Residential-style safety for your RV
●Telescopic rail extends 42.5” from the RV wall
●Provides secure, continuous rail surface
●Easy and quick to install
●Magnetic lock securely holds rail in place during travel


Description

Safe-T-RailSafe-T-Rail

RV Step, Made in the USARV Step, Made in the USA

The Latch Extender is proudly made in the USA with the design and quality you can have confidence in.

Entering and exiting your RV is now easier and safer with the Safe-T-Rail by MORryde. The factory installed folding door handle doesn’t provide enough support for most RVers. However, the MORryde Safe-T-Rail replaces the factory handle and provides a secure, continuous rail surface to support you all the way up and down your entry steps.

  • Provides 54 of continuous rail support
  • Extends 42.5 from the RV wall
  • Collapses against RV wall to store for travel
  • "T" bracket design provides additional side-to-side support
  • Heavy-duty construction
  • Residential-style rail support for your RV
  • Magnetic lock for quick and easy storage
  • *Not intended for use on motorhomes or units with corrugated siding*

Will the Safe-T-Rail Fit Your RV?

Step 1Step 1

Step 2Step 2

Step 3Step 3

Step 4Step 4

Step 1 - Step Well Trim Interference

If there is any trim around the fold out step well, the Safe-T-Rail will not fit or function properly unless it is removed.

Step 2 - Slide Out Interference

If the slide out is closer than 4.25" to the outer edge of the door, the Safe-T-Rail will not fit or function properly

Step 3 - Awning Arm Interference

If the awning bracket is closer than 2.25" to the edge of the door frame and lower than 38" from the bottom of the door, the rail will not fit or function properly.

Step 4 - Window Interference

If a window is closer than 2.25" to the outer door frame and less than 38" from the bottom of the door, the Safe-T-Rail will not fit or function properly.

Step 5Step 5

Step 6Step 6

Step 7Step 7

Step 5 - Check Door Space

A flat unobstructed space of at least 1.875" under the door is required to mount the lower bracket. If a minimum 1.875" does not exist, the bracket will not fit or function properly

Step 6 - Trim Seal

Note that the trim seal between the skirt metal and the wall will have to be cut out for the rail to sit flat against the wall.

Step 7 - Measure

Once it has been determined that the space required for the Safe-T-Rail is clear, measure from the bottom of the door to the top of the lend-a-hand currently on the unit:

  • If the measurement is 38" or less, use the smaller top bracket for installation
  • If the measurement is 38" to 51", use the larger top bracket for installation
Installation InstructionsInstallation Instructions

Product information