Feature

●This turn signal resistor solves hyper flash or no blinking of turn signal
●Easy to Install: you just hook up one side to the positive wire that receives 12 volts when turn signal is on, and the other to the ground wire
●Warning: led turn signal resistor will get really hot as a working halogen bulb,please mount them steadily onto metal surface and keep them off of any plastic parts to avoid plastic from melting down
●Usually each LED bulb installation requires one resistor connected in parellel
●Package Included: 6pcs load resistor,12pcs T-Taps


Description

Description:
Since LED lights dont have much resistance your turn signal will flash very fast if you do not use load resistor. They add resistance and slow down the blink back to normal.

Voltage: DV 12V
Height: 2.2cm（0.86inch）
Length: 5cm(1.96inch)
Weight: 31.47g(1.1oz) per led resistor
Operating temperature: -25 degrees Celsius to +275 degrees Celsius
Package Included: 6pcs 50W 6 ohm Load Resistors with 12 pcs T-Taps

Solution for "bulb out signal" or "OBC error message" after installing SMD LED light bulb
Solution for fast turn signal blinking response after installing SMD LED light bulb

Important:
They got extremely hot, please mount them steadily onto metal surface and keep them off of any plastic parts to avoid plastic from melting down.

Note:
1.If they dont light after inserting into the socket,insert oppositely.
2.Does not matter which side you put to positive, however some cars have 3 wires that lead up to the bulb rather than just 2. Go to your local Audio shop to have them installed if you are not electrically savvy with a 12volt system.