Cleaning and maintenance methods:
1. Please test airbrush kit with clear water before using pigment or paint to ensure that the airbrush is not clogged to spray normally.
2. If the airbrush is not able to spray liquid, it may also be that the liquid regulation knob is too tight, please adjust the end screw. Or it may be that the nozzle is clogged. Please remove and clean the nozzle. Fill the cup with alcohol or detergent, then block the needle cover with a finger and spray. The air flows back into the nozzle to clean the paints that have remained in the airbrush. Please repeat this 2-3 times. Then please wipe off the remaining solvent. Dry the airbrush to avoid stains or rust so you can use it again.
3. If you use acrylic paint, please dilute it with distilled water or with good quality commercial thinners specially made for acrylic paints.
4. After each use of this airbrush, please use clean water or detergent to thoroughly clean the liquid container and nozzle in time and do not let the paint dry so that the nozzle clogs or avoid uneven spraying.
5. The nozzle of this airbrush is only 0.4 mm, so it can only spray watercolour pigments, ink and properly diluted paints. If the paint or liquid is too thick, please dilute it with water or thinner (Note: The concentration of colour and thinner cannot be adjusted higher than milk).
6. If the nozzle is damaged, the airbrush will not work properly, disassemble the nozzle only when it is necessary.