Feature

●Includes 5 supports, 5 pipe clamps, and instructions.
●Fits 1/2", 3/4", and 1" pipes. Supports all pipes including PVC, copper, galvanized piping and electrical conduit. Can handle loads up to 50 lbs.
●Stop using loose scrap materials to support condensate drainage that leads to pipe deterioration and leakage. Use built-in ruler to accurately measure slope to termination point. Easily meet local building codes for minimum pitch requirements.
●Run multiple pipes and Romex wire on one support to increase space efficiency. Supports are stackable for longer runs and more complex installations
●Made in USA with reinforced fiberglass materials. Will not bend, brittle or craze in extreme attic temperatures.


Description

Pitch to Code Every Time!

With the Perfect Pitch, you can quickly and confidently slope pipes or lines to your required pitch. Forget finding scraps or blocks to prop up your HVAC installations.Leave the job site with peace of mind, use Perfect Pitch on your next HVAC install.

Features

universal pipe clampuniversal pipe clamp

stackable designstackable design

multiple linesmultiple lines

built-in rulerbuilt-in ruler

Universal Pipe Clamp

Sturdy design. Holds pipe steady in place. Fits: ½” ¾” 1″ pipes.

Stackable Design

Stack supports for longer runs and more complex installations.

Multiple Lines

Run parallel pipes on one support. Increase space efficiency.

Built-in Ruler

Set pitch to desired intervals using built-in ruler. Measure up to 16”.

Installation Photos

install 1install 1

install 2install 2

install 3install 3

install 4install 4

Instructions

step 1step 1

step 2step 2

step 3step 3

step 4step 4

Step 1

Align Universal Pipe Clamp to Standoff using the ruler indicator*, snap Universal Pipe Clamp onto Standoff at pitch interval needed to meet local, state or federal building code requirements**. Ensure teeth on Universal Pipe Clamp snap into teeth on Standoff.

Step 2

Secure Standoff base onto substrate (i.e. floor or ceiling joists, plywood, etc.) in appropriate location per building code. Use minimum of two screws in opposite slots provided for better stability. Four screws are recommended for all standoffs.

Step 3

Push pipe into side opening on Universal Pipe Clamp to secure.

Step 4

Repeat steps 1-3 on all additional intervals to maintain proper pitch during installation.

american flagamerican flag

Made in USA

All parts of this product are manufactured in the United States.